Technical information

Cuda 12000 IP Access Switch CudaView Administration Guide
Configuring Event Reporting 185
By default, the Cuda 12000 reports events as follows:
Tab l e 8 - 4 Default Event Level Reporting Actions
To configure reporting actions for the associated event levels, follow the
procedure below. Table 8-3, “Reporting Actions” indicates the combination
of reporting actions that are supported by the Cuda 12000.
1. In the Event Configuration window, click the Event Control tab.
2. Within the Priority column, go to the event level for which you want to
configure a reporting action.
3. In the same row of the specific event level, select the reporting action
that you want to configure and right-click. A sub-menu is displayed.
(Refer to Figure 8-3.)
4. Choose Enabled to assign the reporting action to the event level; or,
choose Disabled to remove the reporting action from the event level.
Note: Traps and/or Syslog must be disabled before you can set Local to
Disabled.
5. Repeat step 3 and 4 for each reporting action you want to configure for
the specific event level.
local|traps|syslog Write a message to the internal log, send a
trap, and send a syslog message.
Event Level Default Reporting Action
Emergency local
Alert local
Critical local|traps|syslog
Error local|traps|syslog
Warning local|traps|syslog
Notice local|traps|syslog
Information none
Debug none
Reporting Action Description