Technical information

ADC Telecommunications, Inc.
156 C
HAPTER 7: SIMPLE NETWORK MANAGEMENT PROTOCOL (SNMP)
Deleting an SNMP Community
Follow this procedure to delete an SNMP community:
1. In the Communities window, select the community you wish to delete in
the Communities table.
2. Click Delete. A confirmation window appears.
3. Click Ok to commit the changes or click Cancel to cancel the deletion.
Adding an SNMP Host
SNMP hosts receive event notifications. The SNMP host may be the default
local host on the management module, or an external host that you
configure to receive the notifications.
The local host is the default host that is pre-configured and shipped with
your chassis.Notifications, for the local host, are sent to IP address 127.0.0.1.
If CudaView is installed on the chassis, CudaView uses the local host to
display notifications. The local host IP address should not be changed.
Follow this procedure to add an SNMP host:
1. In the Communities window, select the community in the Communities
table for which you wish to add a host
2. In the Hosts in Selected Community table, click Add. The Add Host
window appears.
3. Enter values for the parameters. Refer to Table 7-14.
4. Click Ok to add the community or click Cancel to exit without saving.
Not In
Service
Disables the entry.
Parameter Description