Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
Cuda 12000 IP Access Switch Installation Guide
Cabling the Management Module 99
Administration Guide or the Cuda 12000 IP Access Switch CudaView
Administration Guide for more information on gaining access to the system.
To cable the CRAFT management interface.
1. Insert the RJ-45 connector on the 10/100BASE-TX cable into the CRAFT
management port until it clicks into place.
2. Connect the other end of the 10/100BASE-T cable to the MDI port on the
network device to which you want to connect.
Figure 5-5 Cabling the CRAFT Management Interface
Power
Fault
Status Display
Active Link
Keyboard
Mouse
Com 1
Com 2
10/100 Enet
To
MDI Port on
Network
Device
BAC_22