Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
ADC Telecommunications, Inc.
98 C
HAPTER 5: CABLING THE SYSTEM
Figure 5-4 shows the cabling of COM port 2 for modem access:
Figure 5-4 Cabling COM 2 for Modem Access
Cabling for Network Access
The 10/100BASE–TX CRAFT management interface uses an RJ-45 connector
and provides a 10/100 Mbps Ethernet connection over UTP-Category 5
copper wire. To gain command line interface (CLI) management access to the
system, Telnet directly into the Management module through this port. If you
have installed CudaView (graphical user interface software), you can point
your Web browser to the address assigned to this port to gain Web-based
management access. Refer to the Cuda 12000 IP Access Switch CLI-based
Power
Fault
Status Display
Active Link
Keyboard
Mouse
Com 2
Com 1
10/100 Enet
BAC 54
To Modem