Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
ADC Telecommunications, Inc.
96 C
HAPTER 5: CABLING THE SYSTEM
Figure 5-2 shows the cabling of COM port 1 for modem access:
Figure 5-2 Cabling COM 1 for Modem Access
Cabling COM 2 for Terminal Access
The Management module also supports local (serial) access through the
COM 2 port located on the front of the Management module. You can use
the ADC-provided serial cable to attach a COM server, terminal emulator, or
a PC running a terminal emulation program to this port to access the
command line interface.
To cable the Management module for local access, have the terminal access
serial cable at hand and use the following procedure:
1. Insert the 8-pin Mini-DIN connector on one end of the cable into the
COM 2 port located on the front of the Management module.
2. Attach the DB-9 connector on the other end of the cable to a COM
server, or a system running a terminal emulation program.
Power
Fault
Status Display
Active Link
Keyboard
Mouse
Com 2
Com 1
10/100 Enet
BAC_54
To Modem