Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
Cuda 12000 IP Access Switch Installation Guide
Cabling the Management Module 95
Figure 5-1 shows the cabling of COM port 1 for terminal access:
Figure 5-1 Cabling COM 1 for Terminal Access
Cabling COM 1 for Modem Access
The Management module also supports modem access through COM 1
located on the front of the Management module. Connection is achieved
using an ADC-provided modem access serial cable. This setup provides
dial-up access to the command line interface.
To cable the Management module for modem access, have the modem
access serial cable at hand and use the following procedure:
1. Insert the 8-pin Mini-DIN connector on one end of the cable into COM 1
located on the front of the Management module.
2. Attach the DB-25 connector on the other end of the cable to the serial
port on the modem.You can then dial into the modem to access the
Cuda 12000 management system.
Power
Fault
Status Display
Active Link
Keyboard
Mouse
Com 2
Com 1
10/100 Enet
To Computer or
COM Server
BAC_53