Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
4
INSTALLING MODULES
This chapter describes how to install and replace system modules in the
Cuda 12000 chassis. Installing and replacing system modules involves the
following steps:
■ Determining Module Location
■ Replacing Filler Panels and Backplates
■ Installing System Modules
■ Removing Modules
CAUTION: Before proceeding with the procedures in this chapter, you
should read Chapter 2, “Preparing for Installation.”
Determining Module Location
The first step in module installation is to determine an appropriate slot in
which to install the module. Cuda 12000 modules are accessible from the
front of the chassis.
When installing modules, you must adhere to specific board orientation
restrictions based on chassis slot number. Chassis slots are numbered from 1
through 14, as shown in Figure 4-1.