Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
ADC Telecommunications, Inc.
70 C
HAPTER 3: RACK-MOUNTING THE SYSTEM
Use this procedure to rack-mount the fan tray:
1. Determine the placement of the fan tray in the rack as described in
“System Placement in the Rack” on page 64.
2. Position the fan tray so that the front end that contains the filtering
screen is facing towards you.
3. Position the fan tray above the intake plenum, then insert the fan tray
into the rack. Ensure that the front brackets on each side of the fan tray
unit meet the mounting posts on each side of the rack, as shown in
Figure 3-5.
4. Rest the fan tray unit on top of the plenum to ensure an adequate seal
between the bottom of the fan tray and the top of the plenum.
5. While keeping the brackets flush against the mounting posts, position
the fan tray so that the 4 holes in the mounting brackets are aligned with
those in the post.
6. Insert all four screws (2 on each side) into the bracket holes as shown in
Figure 3-5. Using the appropriate tool, tighten all the screws so that each
one goes through the bracket and into the rack-mount post.
Figure 3-5 Rack-Mounting the Fan Tray
Status
Status
Status
BAC_09C
Fan Tray Assembly
(Front End)
Screws (4)
Mounting Bracket