Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
Cuda 12000 IP Access Switch Installation Guide
System Placement in the Rack 65
Placement of a Single-Chassis Installation
A single chassis installation occupies a minimum of 15 U’s of vertical rack
space. This includes 9 U’s for the chassis, and 2 U’s for the fan tray and each
plenum. If this unit is the only device in the rack, it should be mounted
towards the bottom of the rack. Figure 3-1 shows the proper rack-mount
installation of a single chassis.
Figure 3-1 Single-Chassis Setup
ON
1
0
OFF
ON
1
0
OFF
Power
Fault
Status Display
Power
Fault
Status Display
Power
Fault
Status Display
Active Link
Keyboard
Mouse
Com 1
Com 2
10/100 Enet
Power
Fault
Status Display
Active Link
Keyboard
Mouse
Com 1
Com 2
10/100 Enet
Power
Fault
Status Display
Read Manual
before actuating
button
1
2
3
4
5
6
7
8
Active
FDX
Link
100 MB
Port
15 Us
9 Us
2 Us
2 Us
2 Us
3 Us
BAC_05C
Chassis
Exhaust
Plenum
Fan Tray
Intake
Plenum