Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
Cuda 12000 IP Access Switch Installation Guide
Tools for Installation 61
Tools for Installation
You need these tools and equipment for proper installation of the Cuda
12000:
■ #1 Phillips screwdriver
■ #2 Phillips screwdriver
■ 7/16” socket or wrench
■ Antistatic mat if you plan to remove system modules
■ ESD grounding strap to prevent Electrostatic Discharge Damage
■ Tape measure, especially if you plan to rack-mount the chassis in a
partially filled rack