Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index

ADC Telecommunications, Inc.
42 C
HAPTER 1: HARDWARE OVERVIEW
Figure 1-11 shows an Octal 10/100 Ethernet SpectraFlow module. For a
description of each numbered callout, see Table 1-2 on page 26.
Figure 1-11 Octal 10/100 Ethernet SpectraFlow Module
100 MB Illuminates when link speed is 100 Mbps; otherwise speed
is 10 Mbps.
LED Description
BAC_20A
Powe r
Fault
Status Display
PORT
100 MB
LINK
FDX
ACTIVE
1
2
3
4
5
6
7
8
R
e
a
d
M
a
n
u
a
l
b
e
f
o
r
e
a
c
t
u
a
t
in
g
b
u
t
t
o
n
SDRAM (11)
SDRAM (10)
Mesh Connector (13)
Management (15)
Mesh Communication Chip (12)
Synchronous Burst
Static RAM (9)
Ethernet (14)
Power Filter (20)
IXP 1200 Network Processor (8)
MAC Chip (17)
Ejector Lever (5)
Reset Button (4)
Power (1)
Fault (2)
Status Display (3)
Ejector Lever (5)
Power Supply (16)
Port Status
Display (21)
Phy Chips (18)
Reserved for Pentium Module (6)
Compact FLASH (7)
Temperature Sensor (19)