Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
ADC Telecommunications, Inc.
30 C
HAPTER 1: HARDWARE OVERVIEW
The 1x4 DOCSIS module has been designed to the DOCSIS 1.0 and DOCISIS
1.1 specifications.
Figure 1-5 1x4 DOCSIS Module
BAC_04A
Ejector Lever (5)
Reset Button (4)
Power (1)
Fault (2)
Status Display (3)
Upstream
Ports
SDRAM (11)
SDRAM (10)
Pentium II
Processor (6)
Mesh Connector (13)
Management (15)
Mesh Communication Chip (12)
Synchronous Burst Static RAM (9)
FLASH
Memory (7)
Ethernet (14)
IXP 1200 Network Processor (8)
Temperature Sensor (19)
MAC Chip (17)
Phy Chip (18)
Ejector Lever (5)
Receive Test Port
(Rx 0dB)
Transmit Test Port
(Tx -30dB)
Power Supply (16)
RF Board
Downstream
Port
Shielded Connector
Powe r
Fault
S
ta
tu
s
D
is
p
la
y
Rx 0dB
Tx -30dB