Installation guide

ADC Telecommunications, Inc.
24 C
HAPTER 1: HARDWARE OVERVIEW
Table 1-1 Management Module Components
Component Description
Power (1) Single green LED that indicates module is
receiving power and the initial startup circuitry is
working.
Fault (2) Single red LED that indicates fault conditions
exist.
Status display (3) 8-character LED panel that displays module
status.
Reset button (4) Resets the module.
Keyboard connector (5) Mini-DIN, 6-pin connector used to attach
keyboard.
Mouse connector (6) Mini-DIN, 6-pin connector used to attach mouse.
COM 1 (7)
Mini-DIN, 8-pin connector.
COM 2 (8)
Mini-DIN, 8-pin connector.
CRAFT Management
Interface (9)
RJ-45 port for connection to a 10/100 Ethernet
network. Used for out-of-band remote and
diagnostic management access.
Video port (10) DB-15 Type II video port for connection to
monitor.
Ejector levers (11) Used to seat or eject modules.
Pentium processor (12) Module processing unit.
Compact FLASH (13) Compact FLASH disk socket. Used by the
processor primarily for BIOS, diagnostics and the
latest configuration file. Reserved for future
functionality.
Hard drive (14) Hard disk used by the Pentium in support of the
Cuda operating system.
SDRAM (15) Two 128-megabyte DIMMs provide the pentium
with 256 megabytes of synchronous SDRAM for
processing of system management functions.
Management connector (16) Connects the module to a management BUS that
consists of two management channels.
Power supply components
(17)
Includes a DC-to-DC converter that converts the
incoming 48 volt power distribution to
appropriate voltages for individual module
components.