Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
168 INDEX
R
rack mounting
chassis 71
determining system placement in 64
fan tray assembly 69
plenums 74
safety guidelines 58
redundant system features 13
removing modules 90
requirements, site 60
RF connectors, for slot 1 20
RJ-21 champ connectors 20, 41
RJ-21 port 54
route server module 16
routing support 16
S
safety
electrical guidelines and precautions 59
when lifting 58
when rackmounting 58
SDRAM 24, 27
serial access
cabling 94
site requirements 60
slot 1 F connectors 21
slot 1, and RF port configuration 20
slot backplates 83
slot numbering 77
slow-blow fuse cartridges 119
SpectraFlow 26
SpectraFlow application modules 26
SpectraFlow DOCSIS/EuroDOCSIS Modules with
Spectrum Management (SPM) 26
Spectrum Management 26
status display 24, 26
synchronous burst static RAM 16, 27
system
location on network 15
overview 15
powering off 131
powering on 125
system cooling, and filler panels 80
system redundancy 13
system, minimum configuration 16
T
TAC 25, 120
technical support 12
temperature sensor 28
temperature sensor, on fan tray assembly 49
terminal access
cabling 94, 96
terminals, earth ground 20
timing and alarms controller (TAC) 25, 120
tools, required for installation 61
troubleshooting 133
U
unused slots, and filler panels 80
UTP Category 5 wire, and Ethernet modules 41
V
video adapter 25
W
wiring diagram
cabling fault reporting 147
cabling serial access
modem 146
terminal 145