Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
Cuda 12000 IP Access Switch Installation Guide
Basic Troubleshooting 143
3. A PS2266 module may be shorted internally, and therefore would cause the
entire power supply chassis to short.
Try installing one module at a time
and check for voltage output after each one is installed.
Note: Each of the four PS2266 modules delivers 1000 watts max (53Vdc @
19 amps). The power supply chassis with all four power supply modules in
and powered on provides 4000 watts. Refer to the “Connecting Power”
section on page 109 to determine how much power is required for your
configuration.