Installation guide

C
MARTEK POWER SUPPLY
ADC offers an optional power supply that can be used to power the Cuda
12000. The power supply system offered by ADC is the Martek power supply
model PS2266 and bay model B2266.
Additional information and specifications can be obtained from the Martek
Web site at: http://www.martekpower.com.
WARNING: High voltage power supplies are extremely dangerous and
should only be handled by a qualified electrical technician. Injury or death
may result from improper handling.
To protect you from potentially deadly electrical shock hazards as well as the
equipment from accidental damage, do not attempt to repair, or modify the
power supply and/or the bay.
Altering or modifying the power supply and/or bay without the written
consent of Martek Power Inc. may invalidate the limited warranty.
This appendix explains the functionality of the front panel LEDs for the
Martek power supply and some basic troubleshooting techniques .
Front Panel LEDs
This section describes the front panel LED indicators and the wiring logic.
The following table provides a description of each LED:
LED Description
Green LED
A status indicator of the output voltage. If the output voltage
is above 40Vdc (+/- 5%) the green LED should be on. If the
output voltage is less than 40Vdc (+/-5%) the green LED
should be off.