Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
Cuda 12000 IP Access Switch Installation Guide
Cabling for System Fault Reporting 123
Figure 5-21 shows the cabling of the Alarms In DB-15 connector on the rear
chassis panel to the fan tray and the power source using the 3-way cable.
Figure 5-21 Cabling for Fault Reporting with 3-way Cable
Refer to Appendix C for fault reporting wiring diagrams.
BAC_66
J11
J10
J9
J8
J7
J6
J5
J4
J3
J2
J1
Alarms
In
TAC
Cable
To
Earth
Ground
To
Power
Source