Installation guide
Table Of Contents
- About This Guide
- Hardware Overview
- Preparing for Installation
- Rack-Mounting the System
- Installing Modules
- Cabling the System
- Powering On and Powering Off
- Configuring Network Access
- System Specifications and Compliance
- Martek Power Supply
- Wiring Diagrams
- Glossary
- Index
Cuda 12000 IP Access Switch Installation Guide
Cabling Octal 10/100 Ethernet SpectraFlow Modules 105
For example, Figure 5-8 shows the proper cabling of chassis slot 9 for a
10/100 Ethernet module.
Figure 5-8 Cabling a 10/100 Ethernet Slot
To cable a Cat 5 Ethernet patch panel to your network, follow this
procedure:
1. Locate the group of RJ-45 ports on the front of the patch panel that
correspond to the RJ-21 connector that you installed on the back of the
panel, as shown in Figure 5-8.
2. Insert the RJ-45 connector from an Ethernet patch cable into one of the
RJ-45 ports located in step 1.
3. Connect the other end of the Ethernet patch cable to your network.
4. Repeat steps 1 through 3 for all Ethernet ports that you want to connect
to your network.
Figure 5-9 shows the cabling of Ethernet patch panel port 5 to a network.
BAC_26C
J
1
1
J
1
0
J
8
J
7
J
6
J
5
J
4
J
3
J
2
J
1
J
9
Rear View of
Cat 5E
Ethernet
Patch Panel
Cat 5E
Patch Cable
RJ-21
Connector