Technical information

ADC Telecommunications, Inc.
72 CHAPTER 2: CUDA 12000 BASE SYSTEM COMMANDS
bridge-interface
Use this command within interface configuration mode to add a physical interface to the current
bridge group.
To add a physical interface to a bridge group, do the following:
■ If you haven’t already done so, use the bridge-group command to create a bridge group.
■ Enter interface configuration mode for the specified bridge group using the interface
bridge-group command.
■ While in interface configuration mode, add a physical interface to the current bridge group
using the bridge-interface command.
Use the no bridge-interface command to remove a physical interface from the current bridge
group.
Mode
interface:bridge-group(bridge group)
Syntax
bridge-interface <c/s/i>
no bridge-interface <c/s/i>
Arguments
<c/s/i> The chassis/slot/interface combination that identifies the physical
interface that you want to add to the bridge-group.