Technical information

ADC Telecommunications, Inc.
58 CHAPTER 2: CUDA 12000 BASE SYSTEM COMMANDS
aux-device db15 alarm
Configures the alarms out port, which is a DB-15 connector on the Cuda 12000 chassis rear
panel. You can configure the Cuda 12000 to send specific types of alarm signals out this
connector to notify an external device that a fault has occurred. The command disables sending
of specific alarms. Use the no form of the command to enable sending of specific alarms.
Mode
root
Syntax
aux-device db15 alarm
{blue | clock [bits-a] [bits-b] [red-alarm] |
power-alarm [backplane-power] [backplane-pwr-a] [backplane-pwr-b]
[local-pwr-a] [local-pwr-b] [ps-ac] [ps-dc] | power-fail-A |
power-fail-B | red [bits-a] [bits-b] [red-alarm] |
system [backplane] [backplane-power] [backplane-temp]
[fan-rotation] [fan-temp] [local-pwr-a] [local-pwr-b] [ps-ac]
[ps-dc] [ps-temp] [red-alarm] | temp [backplane-temp] [fan-temp]
[processor-temp] [ps-temp] | yellow}
no aux-device db15 alarm
{blue | clock [bits-a] [bits-b] [red-alarm] |
power-alarm [backplane-power] [backplane-pwr-a] [backplane-pwr-b]
[local-pwr-a] [local-pwr-b] [ps-ac] [ps-dc] | power-fail-A |
power-fail-B | red [bits-a] [bits-b] [red-alarm] |
system [backplane] [backplane-power] [backplane-temp]
[fan-rotation] [fan-temp] [local-pwr-a] [local-pwr-b] [ps-ac]
[ps-dc] [ps-temp] [red-alarm] | temp [backplane-temp] [fan-temp]
[processor-temp] [ps-temp] | yellow}