Technical information

ADC Telecommunications, Inc.
570 CHAPTER 2: CUDA 12000 BASE SYSTEM COMMANDS
local-sonet-alarm A SONET local alarm is occurring. This notification type has an
“error” priority. Refer to the description of the event-config
reporting command for more information on event priorities.
ospf-nbr-state Signifies a change in the state of an OSPF neighbor on a
physical interface. This notification type has a “notice”
priority. To send this notification type, note that you also have
to enable sending of OSPF neighbor state traps using the
report command. Refer to the description of the report
command on page 348 for more information.
ospf-virt-nbr-state Signifies a change in the state of an OSPF neighbor on a virtual
interface. This notification type has a “notice” priority. To
send this notification type, note that you also have to enable
sending of OSPF virtual neighbor state traps using the report
command. Refer to the description of the report command
on page 348 for more information.
prov-service A FastFlow BPM service started, stopped, or failed. This
notification type has a “notice” priority. Refer to the
description of the event-config reporting command for
more information on event priorities.
remote-sonet-alarm A SONET remote alarm is occurring. This notification type has
an “error” priority. Refer to the description of the
event-config reporting command for more information on
event priorities.
subnet-addr-high The free IP address count exceeded the high available address
threshold for a subnet. This notification type has a “notice”
priority. Refer to the description of the event-config
reporting command for more information on event priorities.
subnet-addr-low The free IP address count fell below the low available address
threshold for a subnet. This notification type has a “notice”
priority. Refer to the description of the event-config
reporting command for more information on event priorities.
trace-log For ADC internal use only. This notification type has a
“notice” priority. Refer to the description of the event-config
reporting command for more information on event priorities.
warm-start Signifies that the SNMP entity on the Cuda 12000, acting in
an agent role, is reinitializing itself such that its configuration is
unaltered. This notification type has a “notice” priority. Refer
to the description of the event-config reporting command
for more information on event priorities.
Notification Type Indicates that...