Technical information

Cuda 12000 IP Access Switch CLI Reference Guide

show modem <mac-address> 467

show modem <mac-address>

Queries a specified cable modem directly to retrieve and display its current MIB values, which are

described in MIB II, RFC2669, RFC2670, the Baseline Privacy Interface (BPI) and BPI Plus

specifications, and other cable modem networking standards documents and MIBs. If you do not

specify a read community string, the command sends the default read community string to the

cable modem.

Mode

root

interface:cable:csi(<c/s/i>)

Syntax

show [interface cable <c/s/i>] modem <mac-address>

{cm {bpi-base | bpi-plus {base | tek} | bpi-tek | device [event

{config | control | list} [read-community <string>] | downstream |

system | upstream} | cm-filter | cpe-control | cpe-hosts |

service-flow {classifier [<cid> | phs] | log [<log-id>] |

parameter-set [<type>] | stats | upstream}}

Arguments

interface cable <c/s/i> Specifies the chassis, slot, interface of the cable modem for

which you want to display the status.

<mac-address> Specifies the MAC address of the cable modem.