Technical information

Cuda 12000 IP Access Switch CLI Reference Guide
ppp ipcp-report-address 325
ppp ipcp-report-address
Configures the current POS interface to provide its IP address during Internet Protocol Control
Protocol (IPCP) negotiations when creating a point-to-point link.
When creating a link with a Juniper Networks router, you must disable IPCP address reporting
using the no ppp ipcp-report-address command; the Juniper router will not complete PPP
negotiations if the Cuda 12000 provides its IP address during IPCP negotiations.
Mode
interface:pos:csi(<c/s/i>)
Syntax
ppp ipcp-report-address
Example
cli# interface 1/3/1
mode: interface:pos:csi(1/3/1)
cli# ppp ipcp-report-address
cli#
Related Commands
■ no ppp ipcp-report-address on page 287
■ show interface pos on page 437