Technical information

ADC Telecommunications, Inc.
318 CHAPTER 2: CUDA 12000 BASE SYSTEM COMMANDS
Arguments
lais Configures the POS interface to report line alarm indication signal
errors.
lrdi Configures the POS interface to report line remote defect indication
errors.
pais Configures the POS interface to report path alarm indication signal
errors. Used to alert the downstream path terminating equipment (PTE)
that the interface has detected a defect on its incoming line signal.
plop Configures the POS interface to report path loss of pointer errors.
Reported by default. This defect is reported as a result of either of the
following:
■ Invalid pointer (H1, H2)
■ Excess number of new data flag (NDF) enabled indications.
prdi Configures the POS interface to report path remote defect indication
errors.
sd-ber Configures the POS interface to report signal degradation BER errors.
sf-ber Configures the POS interface to report signal failure BER errors.
Reported by default.
slof Configures the POS interface to report section loss of frame errors.
Reported by default. Detected when the POS interface sees a severely
error framing (SEF) defect on the incoming SONET signal for 3
milliseconds.
slos Configures the POS interface to report section loss of signal errors.
Reported by default. Detected when the POS interface sees an all-zeros
pattern on the incoming SONET signal which lasts 19 microseconds or
longer.