Technical information

Cuda 12000 IP Access Switch CLI Reference Guide
no ppp ipcp-report-address 287
no ppp ipcp-report-address
Used when the Cuda 12000 must interact with a Juniper Networks system. This command
configures the current POS interface so that it does not provide its IP address during Internet
Protocol Control Protocol (IPCP) negotiations.
The Juniper router will not complete PPP negotiations if the Cuda 12000 provides its IP address
during IPCP negotiations. Therefore if a PPP connection is being brought up between these two
systems, you must issue the no ppp ipcp-report-address command. Note that the Cuda 12000
reports its IP address during IPCP negotiations by default.
Mode
interface:pos:csi(<c/s/i>)
Syntax
no ppp ipcp-report-address
Example
cli# interface 1/3/1
mode: interface:pos:csi(1/3/1)
cli# no ppp ipcp-report-address
cli#
Related Commands
■ interface on page 181
■ ppp ipcp-report-address on page 325
■ show interface on page 414