Technical information

ADC Telecommunications, Inc.
280 CHAPTER 2: CUDA 12000 BASE SYSTEM COMMANDS
no pos flag
Use this command to remove the setting of the following overhead byte values:
■ c2 — This byte serves as a signal label and indicates the content held within the synchronous
payload envelope (SPE) of the SONET frame, as well as the status of that payload.
■ J0 — The section trace byte required for interoperability with some SDH devices in Japan.
Use the pos flag command to configure these SONET overhead byte values.
Mode
interface:pos:csi(<c/s/i>)
Syntax
no pos flag {c2 | j0} <value>
Arguments
Example
cli# interface 1/3/1
mode: interface:pos:csi(1/3/1)
cli# no pos flag c2
cli#
Related Commands
■ interface on page 181
■ pos flag on page 316
■ show interface pos on page 437
c2 <value> Path signal identifier used to identify the payload content type.
Valid range: 0 – 255.
j0 <value> Section trace byte. For interoperability with SDH equipment.
Valid range: 0 – 255.