Technical information

Cuda 12000 IP Access Switch CLI Reference Guide
negotiation auto 259
negotiation auto
Configures an Ethernet port to automatically negotiate duplex mode and speed. If you had
explicitly configured the duplex mode for full or half, or explicitly configured speed for 10 Mbps
or 100 Mbps, then these settings are no longer in effect.
Use the no form of the command to disable the ability to automatically negotiate duplex mode
and speed. If you had previously used the duplex and speed commands to configure the ability
to automatically negotiate duplex and speed, the no negotiation auto command resets the
duplex mode and speed to their previous explicit settings.
Mode
interface:ethernet:csi(<c/s/i>)
Syntax
negotiation auto
no negotiation auto
Example
cli:192.168.208.3:interface:ethernet:csi(1/11/1)# negotiation auto
cli:192.168.208.3:interface:ethernet:csi(1/11/1)# show interface
Interface 1/11/1 Ethernet (100 Mb)
Configured duplex auto
Configured speed auto
Auto-negotiation enable
In octets 0
In unicast 0
In multicast 0
In broadcast 0
Out octets 0
Out unicast 0
Out multicast 0
Out broadcast 0
Related Commands
■ duplex on page 156
■ show interface ethernet on page 435
■ speed on page 582