Technical information

Cuda 12000 IP Access Switch CLI Reference Guide
ip rip enable 227
ip rip enable
Enables Routing Information Protocol (RIP) on the current interface.
If send-version is not specified then the interface is configured with send-version defaulting to
ripv1 compatible mode. That is, RIP transmits both RIPv1 and RIPv2 packets. If receive-version is
not specified then the interface is configured with receive-version defaulting to both RIPv1 and
RIPv2 mode. That is, RIP receives both RIPv1 and RIPv2 packets.
Mode
interface:<type>:csi(<c/s/i>):ip-address(<ip-address>)#
Syntax
ip rip enable
Example
cli:# ip rip enable
cli:# show ip rip
IP Address 201.1.1.1
Send Version RIPv1
Receive Version RIPv1 Or RIPv2
Cost 1
Authentication ON False
Authentication Type No Authentication
Authentication Key Id 0
Send Default Only False
Send Default Also True
Default Cost 3
Accept Default True
Accept Host Route True
Split Horizon True
Poisoned Reverse True
Status Active