Technical information

Cuda 12000 IP Access Switch CLI Reference Guide
ip rip disable 225
ip rip disable
This command can be used to either disable an existing RIP interface or create a new RIP interface
in the disabled state and use defaults for send-version and receive-version.
If the administrator uses this command to initially create a RIP interface then the send-version is
defaulted to ripv1 compatible mode. That is, RIP transmits both RIPv1 and RIPv2 packets. Similarly
receive-version is defaulted to both RIPv1 and RIPv2 mode. That is, RIP transmits both RIPv1 and
RIPv2 packets.
Mode
interface:<type>:csi(<c/s/i>):ip-address(<ip-address>)#
Syntax
ip rip disable
Example
cli:# interface 1/1/1
mode: interface:cable:csi(1/1/1)
cli:# ip address 201.1.1.1 255.255.255.0
cli:# ip rip disable
cli:# show ip rip
IP Address 201.1.1.1
Send Version RIPv1
Receive Version RIPv1 Or RIPv2
Cost 1
Authentication ON False
Authentication Type No Authentication
Authentication Key Id 0
Send Default Only False
Send Default Also True
Default Cost 3
Accept Default True
Accept Host Route True
Split Horizon True
Poisoned Reverse True
Status Not In Service