Technical information

Cuda 12000 IP Access Switch CLI Reference Guide
ip ospf transit-delay 211
ip ospf transit-delay
Sets the number of seconds it takes to transmit a link state update packet on the current OSPF
interface. Note the following:
■ You execute this command from IP interface mode.
■ Once within this mode, you must specify the IP interface to which you want to apply the
OSPF configuration using the ip address command.
■ You must have already defined one or more ospf areas with the ospf area command within
router:ospf mode. You must apply an ospf area to the current interface using the ip ospf
area-id before you use this command.
■ Use the show ip ospf command to display the OSPF configuration for the current interface.
Mode
interface:<type>:csi(<c/s/i>):ip-address(<ip-address>)#
Syntax
ip ospf transit-delay <number>
Arguments
<number> Time, in seconds, that it takes to transmit a link state update over this
OSPF interface. Valid range is 1 to 65535. The default is 1.