Technical information

ADC Telecommunications, Inc.
202 CHAPTER 2: CUDA 12000 BASE SYSTEM COMMANDS
ip ospf hello-interval
Specifies the length of time, in seconds, the router waits between sending Hello packets on the
current OSPF interface. Note the following:
■ You execute this command from IP interface mode.
■ Once within this mode, you must specify the IP interface to which you want to apply the
OSPF configuration using the ip address command.
■ You must have already defined one or more ospf areas with the ospf area command within
router:ospf mode. You must apply an ospf area to the current interface using the ip ospf
area-id command before you use this command.
■ Use the show ip ospf command to display the OSPF configuration for the current interface.
Mode
interface:<type>:csi(<c/s/i>):ip-address(<ip-address>)#
Syntax
ip ospf hello-interval <seconds>
Arguments
<seconds> Interval, in seconds, between Hello packet transmissions. Valid range is
1 to 65535 seconds. The default is 10.