Technical information

ADC Telecommunications, Inc.
132 CHAPTER 2: CUDA 12000 BASE SYSTEM COMMANDS
cpe-control max-ip
Specifies the default maximum number of CPE IP addresses that can access the network through
a single cable modem. You can use the cm modify max-ip command to override this default
setting on a modem-by-modem basis.
Use the no form of the command to set the maximum number of CPE IP addresses to zero.
Mode
Any.
Syntax
cpe-control max-ip <number>
no cpe-control max-ip
Arguments
Example
cli:interface:cable:csi(1/1/1)# cpe-control max-ip 16
cli:interface:cable:csi(1/1/1)# show cpe-control
MAX IP 16
Active False
Learnable True
Related Commands
■ cm modify max-ip on page 121
■ cpe-control active on page 130
■ cpe-control learnable on page 131
■ show cpe-control on page 395
■ show interface cable <c/s/i> cpe-control on page 416
<number> Specifies the default maximum number of IP addresses of CPE devices
that can access the network through a single cable modem. Values range
from 0 (no CPE devices allowed) to 16 (the default).