Technical information

ADC Telecommunications, Inc.
130 CHAPTER 2: CUDA 12000 BASE SYSTEM COMMANDS
cpe-control active
Specifies whether the CMTS performs subscriber management (such as filtering and enforcing
CPE address limits) by default for cable modems. You can use the cm modify active command
to override this default setting on a modem-by-modem basis.
Use the no form of the command to disable subscriber management.
Mode
Any.
Syntax
cpe-control active
no cpe-control active
Example
cli:interface:cable:csi(1/1/1)# cpe-control active
cli:interface:cable:csi(1/1/1)# show cpe-control
MAX IP 16
Active True
Learnable True
Related Commands
■ cm modify active on page 109
■ cpe-control learnable on page 131
■ cpe-control max-ip on page 132
■ show cpe-control on page 395
■ show interface cable <c/s/i> cpe-control on page 416