Technical information

Cuda 12000 IP Access Switch CLI Reference Guide
cm modify max-ip 121
cm modify max-ip
Sets the maximum number of IP addresses of CPE devices that can access the network through
the specified cable modem. The value that this command specifies overrides the default that the
cpe-control max-ip command specifies.
Mode
interface:cable:csi(<c/s/i>)
Syntax
cm modify max-ip <number> {<ip-address> | <mac-address> | <sid>}
Arguments
<number> Specifies the maximum number of IP addresses of CPE devices that can
access the network through the specified cable modem. Values range
from 0 (no CPE allowed) to 16. The default value is the value set by the
cpe-control max-ip command.
{<ip-address> |
<mac-address> |
<sid>}
Specifies one of the following values:
■ <ip-address> – The IP address of the cable modem that provides
network access to CPE.
■ <mac-address> – The MAC address (in xx:xx:xx:xx:xx:xx format) of
the cable modem that provides network access to CPE.
■ <sid> – The service identifier of the cable modem that provides
network access to CPE.
Use the show modem command to determine the IP address, MAC
address, and service identifier of the cable modem.