Technical information

Cuda 12000 IP Access Switch CLI Reference Guide
cm cpe-reset 105
Example 1
The following example clears CPE IP addresses for a single modem with the SID of 667.
cli:192.168.208.3:interface:cable:csi(1/1/1)# show modem
row count: 12
MAC Address IP Address SID CID CPE D:U Power Timing Modem
(dbMV) State
----------------- --------------- ---- ---- --- --- ------ ------ -------
00:90:96:00:29:6d 201.1.1.103 667 1 10 1:2 0 2219 Registered
00:10:95:01:ef:d8 201.1.1.100 673 1 10 1:2 0 2212 Registered
00:10:95:04:0a:c4 201.1.1.102 676 1 10 1:2 0 2724 Registered
00:90:96:00:39:f9 201.1.1.101 668 1 10 1:2 0 2220 Registered
00:10:95:04:0a:b7 201.1.1.105 675 1 10 1:2 0 2729 Registered
00:90:96:00:29:71 201.1.1.104 670 1 10 1:2 0 2217 Registered
00:10:95:04:0a:bd 201.1.1.106 677 1 10 1:2 1 2728 Registered
00:10:95:01:f0:05 201.1.1.107 674 1 10 1:2 0 2211 Registered
00:90:83:36:82:f1 201.1.1.110 669 1 10 1:2 0 1244 Registered
00:90:83:32:9f:8c 201.1.1.111 666 1 10 1:2 0 1653 Registered
00:10:95:04:0a:c3 0.0.0.0 62 0 0 1:2 -8 2729 Ranging
cli:192.168.208.3:interface:cable:csi(1/1/1)# cm cpe-reset 667
<address-string> Specifies the IP address that you want to match, which you enter with a
“255” wildcard mask. For example, if you want to clear CPE IP
addresses for all cable modems attached to subnet 189.23.3.x, enter the
following command: cm cpe-reset 189.23.3.255 match
match Keyword used to define an address or MAC address match.