Campus-REX RS Interface Card User Manual
Table Of Contents
- About the Product
- Installing theCampusREXRS InterfaceCard
- Set Up the CampusREXSystem
- Configuring andMonitoring throughthe LCD
- Configuring with an ASCII Terminal
- Setting Up and Logging On to an ASCIITerminal
- Logging Onto a Remote Campus Unit
- Logging Off of a Campus Unit
- Using the Terminal Menus
- Returning Configuration Options to Default Values
- Configuring the CampusREX for SNMP Management
- Configuring Startup Parameters
- Configuring the CampusREX as a Master or Slave Unit
- Configuring Alarms
- Entering System Information
- Configuring Loopbacks
- Updating the CampusREX Firmware
- Monitoring with anASCII Terminal
- Internetworking and Management Overview
- Technical Reference
- Abbreviations
- The Documentation Set
- Contacting ADC
Configuring and Monitoring through the LCD
Campus-REX RS Interface Card User Manual 4-13
To view the system information:
1 Press Escape until CAMPUS RS I/F: REX displays.
2 Press Enter to view the firmware version and PROM checksum.
3 Press Next to scroll through the remaining options.
VIEWING STATUS INFORMATION
The LCD provides access to the following status information:
• Ethernet information, such as the MAC address and 10BASE-T status
• Current HDSL margin
• Frame statistics on the Ethernet and HDSL ports
Ethernet Information
You can view the following information about the Ethernet port:
• MAC address
• current 10BASE-T status
To view Ethernet information:
1 Press Escape until CAMPUS RS I/F: REX displays.
2 Press Next twice. DATA PORT CONFIG & STATUS displays.
3 Press Enter. CONFIGURE REX SETTINGS displays.
4 Press Next to view the MAC ADDRESS.
5 Press Next again to view the current status of the 10BASE-T port.
CAD1069i5.book Page 13 Thursday, May 30, 2002 7:32 AM