Campus-REX RS Interface Card User Manual
Table Of Contents
- About the Product
- Installing theCampusREXRS InterfaceCard
- Set Up the CampusREXSystem
- Configuring andMonitoring throughthe LCD
- Configuring with an ASCII Terminal
- Setting Up and Logging On to an ASCIITerminal
- Logging Onto a Remote Campus Unit
- Logging Off of a Campus Unit
- Using the Terminal Menus
- Returning Configuration Options to Default Values
- Configuring the CampusREX for SNMP Management
- Configuring Startup Parameters
- Configuring the CampusREX as a Master or Slave Unit
- Configuring Alarms
- Entering System Information
- Configuring Loopbacks
- Updating the CampusREX Firmware
- Monitoring with anASCII Terminal
- Internetworking and Management Overview
- Technical Reference
- Abbreviations
- The Documentation Set
- Contacting ADC
Configuring and Monitoring through the LCD
Campus-REX RS Interface Card User Manual 4-11
You manage loopbacks through the DIAGNOSTICS menu:
1 Press Escape until CAMPUS RS I/F: REX displays.
2 Press Next four times. DIAGNOSTICS displays.
3 Press Enter. LOOPBACK MODE displays.
The following sections describe how to initiate and clear loopbacks, and to
set a loopback timeout.
Initiating a Loopback
To initiate a loopback condition:
1 From the LOOPBACK MODE display, press Enter.
2 Press Next to scroll through the loopback options until the desired
loopback condition displays.
3 Press Enter to initiate the loopback. LOOPBACK MODE displays.
Clearing a Loopback
To clear a loopback condition:
1 From the LOOPBACK MODE display, press Enter.
2 Press Next to scroll through the loopback options until NONE displays.
3 Press Enter to clear the loopback. LOOPBACK MODE displays.
CAD1069i5.book Page 11 Thursday, May 30, 2002 7:32 AM