Campus-REX RS Interface Card User Manual
Table Of Contents
- About the Product
- Installing theCampusREXRS InterfaceCard
- Set Up the CampusREXSystem
- Configuring andMonitoring throughthe LCD
- Configuring with an ASCII Terminal
- Setting Up and Logging On to an ASCIITerminal
- Logging Onto a Remote Campus Unit
- Logging Off of a Campus Unit
- Using the Terminal Menus
- Returning Configuration Options to Default Values
- Configuring the CampusREX for SNMP Management
- Configuring Startup Parameters
- Configuring the CampusREX as a Master or Slave Unit
- Configuring Alarms
- Entering System Information
- Configuring Loopbacks
- Updating the CampusREX Firmware
- Monitoring with anASCII Terminal
- Internetworking and Management Overview
- Technical Reference
- Abbreviations
- The Documentation Set
- Contacting ADC
Installing the Campus-REX RS Interface Card
Campus-REX RS Interface Card User Manual 2-7
POWER UP AND CHECK THE ETHERNET LINE
1 Verify that the power cord is connected to the Desktop Unit or to the
Campus-Star chassis (if you have an AC power supply) and to an
external power source.
2 Do one of the following:
• If the Campus-REX is installed in a Desktop Unit, press the power
button on the back of the Desktop Unit.
• If the Campus-REX is installed in a Campus-Star, continue with
Step 3.
3 Verify that the Link LED on the Campus-REX card is green. This
indicates that the 10BASE-T connection is operating correctly. If the
Link LED does not light green, check the 10BASE-T cabling
configuration.
CAD1069i5.book Page 7 Thursday, May 30, 2002 7:32 AM