Campus-REX RS Interface Card User Manual
Table Of Contents
- About the Product
- Installing theCampusREXRS InterfaceCard
- Set Up the CampusREXSystem
- Configuring andMonitoring throughthe LCD
- Configuring with an ASCII Terminal
- Setting Up and Logging On to an ASCIITerminal
- Logging Onto a Remote Campus Unit
- Logging Off of a Campus Unit
- Using the Terminal Menus
- Returning Configuration Options to Default Values
- Configuring the CampusREX for SNMP Management
- Configuring Startup Parameters
- Configuring the CampusREX as a Master or Slave Unit
- Configuring Alarms
- Entering System Information
- Configuring Loopbacks
- Updating the CampusREX Firmware
- Monitoring with anASCII Terminal
- Internetworking and Management Overview
- Technical Reference
- Abbreviations
- The Documentation Set
- Contacting ADC
E-6 Campus-REX RS Interface Card User Manual
timeout
ASCII terminal .......................... 5-23
LCD .......................................... 4-12
timing source ....3-21 to 3-23, 3-29 to 3-31
Transceiver Mode
ASCII terminal ..............5-12 to 5-14
LCD ............................................4-4
transmission rate ........................1-2 to 1-5
setting ..............................3-7 to 3-18
transmitted frames
ASCII terminal ..................6-8 to 6-9
LCD .......................................... 4-14
trap generation .....................................5-9
U
unit ID ................................................ 5-19
updating firmware ............................. 5-24
W
World Wide Web .................................D-1
X
XCVR Mode
See Transceiver Mode
CAD1069i5.book Page 6 Thursday, May 30, 2002 7:32 AM