Campus-REX RS Interface Card User Manual
Table Of Contents
- About the Product
- Installing theCampusREXRS InterfaceCard
- Set Up the CampusREXSystem
- Configuring andMonitoring throughthe LCD
- Configuring with an ASCII Terminal
- Setting Up and Logging On to an ASCIITerminal
- Logging Onto a Remote Campus Unit
- Logging Off of a Campus Unit
- Using the Terminal Menus
- Returning Configuration Options to Default Values
- Configuring the CampusREX for SNMP Management
- Configuring Startup Parameters
- Configuring the CampusREX as a Master or Slave Unit
- Configuring Alarms
- Entering System Information
- Configuring Loopbacks
- Updating the CampusREX Firmware
- Monitoring with anASCII Terminal
- Internetworking and Management Overview
- Technical Reference
- Abbreviations
- The Documentation Set
- Contacting ADC
Technical Reference
Campus-REX RS Interface Card User Manual A-3
LCD MENU REFERENCE
The illustration on the following pages diagrams the LCD menu structure.
CAMPUS RS
I/F: REX
LOCAL UNIT ID
Press ENTER
NEXT
NEXT
ENTER
ENTER
NEXT
NEXT
NEXT
NEXT
NEXT
NEXT
NEXT
NEXT
NEXT
NEXT
NEXT
NEXT
REMOTE UNIT ID
Press ENTER
REMOTE I/F
CIRCUIT ID
Press ENTER
S/W REV
S/W CKSUM
H/W CONFIG
Press ENTER to
factory reset
OPERATING MODE
XCVR MODE
LOOP MODE*
HDSL RATE
MARGIN (LOC/RMT)
HDSL LINK
CONFIG & STATUS
Continued next page
* Option displays only in extended mode.
CAD1069i5.book Page 3 Thursday, May 30, 2002 7:32 AM