Campus-REX RS Interface Card User Manual
Table Of Contents
- About the Product
- Installing theCampusREXRS InterfaceCard
- Set Up the CampusREXSystem
- Configuring andMonitoring throughthe LCD
- Configuring with an ASCII Terminal
- Setting Up and Logging On to an ASCIITerminal
- Logging Onto a Remote Campus Unit
- Logging Off of a Campus Unit
- Using the Terminal Menus
- Returning Configuration Options to Default Values
- Configuring the CampusREX for SNMP Management
- Configuring Startup Parameters
- Configuring the CampusREX as a Master or Slave Unit
- Configuring Alarms
- Entering System Information
- Configuring Loopbacks
- Updating the CampusREX Firmware
- Monitoring with anASCII Terminal
- Internetworking and Management Overview
- Technical Reference
- Abbreviations
- The Documentation Set
- Contacting ADC
Campus-REX RS Interface Card User Manual A-1
A
TECHNICAL REFERENCE
SPECIFICATIONS
Physical
Height 0.7 inches (1.8 cm)
Width 2.8 inches (7.0 cm)
Depth 5.6 inches (14.1 cm)
Weight 4.0 ounces (113.4 gm)
Equipment Interface
Ethernet Port
Connector RJ-45C, 10BASE-T
Bandwidth Filtering 14 kpps (64-byte frames) max
Forwarding 2.7 kpps Full-duplex
Encapsulation Format HDLC or PPP
Bridging IEEE 802.1d Transparent Bridging with
Spanning Tree Protocol
Clock Options
Internal (±50 ppm), HDSL
Electrical
Power Consumption 3.5W max
CAD1069i5.book Page 1 Thursday, May 30, 2002 7:32 AM