Campus-REX RS Interface Card User Manual
Table Of Contents
- About the Product
- Installing theCampusREXRS InterfaceCard
- Set Up the CampusREXSystem
- Configuring andMonitoring throughthe LCD
- Configuring with an ASCII Terminal
- Setting Up and Logging On to an ASCIITerminal
- Logging Onto a Remote Campus Unit
- Logging Off of a Campus Unit
- Using the Terminal Menus
- Returning Configuration Options to Default Values
- Configuring the CampusREX for SNMP Management
- Configuring Startup Parameters
- Configuring the CampusREX as a Master or Slave Unit
- Configuring Alarms
- Entering System Information
- Configuring Loopbacks
- Updating the CampusREX Firmware
- Monitoring with anASCII Terminal
- Internetworking and Management Overview
- Technical Reference
- Abbreviations
- The Documentation Set
- Contacting ADC
Internetworking and Management Overview
Campus-REX RS Interface Card User Manual 7-3
LAN
Bridge 3Bridge 2Bridge 1
Bridge 4
Bridge 5
ENET 1
ENET 3
E
N
E
T
2
Example Physical Network*
LAN
LAN
Bridge 3Bridge 2Bridge 1
Bridge 4
Bridge 5
ENET 1
ENET 3
E
N
E
T
2
Loop-free Topology
Using Spanning Tree Protocol
*This physical configuration is valid only when used
with Spanning Tree to eliminate loops.
LAN
CAD1069i5.book Page 3 Thursday, May 30, 2002 7:32 AM