Datasheet

FS98O22

Rev. 1.6 52/146

property R-0 R-0 R-0 R-0 R-0 R-0 R-0 R-0

TMOUT

TMOUT [7:0]

Bit7 Bit0

Bit 7-0 TMOUT [7:0]: Timer module 8-bit counter output (Please refer to Section 6.1 for detail)

property R/W-1 U-X U-X U-X R/W-0 R/W-0 R/W-0 R/W-0

TMCON

TRST TMEN INS [2:0]

Bit7 Bit0

Bit 7 TRST: Timer Module reset flag (Please refer to Section 6.1 for detail)

1 = Timer Module Counter works normally.

0 = Timer Module Counter is reset.(After resetting the Counter, TRST will reset itself)

Bit 3 TMEN: Timer Module enable flag (Please refer to Section 6.1 for detail)

1 = Timer Module Counter will active.

0 = Timer Module Counter will be disabled.

Bit 2-0 INS [2:0]: Timer Module interrupt Signal Selector (Please refer to Chapter 6.1 for detail)

111 = TMOUT[7] is selected as Timer Module interrupt Signal

110 = TMOUT[6] is selected as Timer Module interrupt Signal

101 = TMOUT[5] is selected as Timer Module interrupt Signal

100 = TMOUT[4] is selected as Timer Module interrupt Signal

011 = TMOUT[3] is selected as Timer Module interrupt Signal

010 = TMOUT[2] is selected as Timer Module interrupt Signal

001 = TMOUT[1] is selected as Timer Module interrupt Signal

000 = TMOUT[0] is selected as Timer Module interrupt Signal

property

R = Readable bit W = Writable bit U = unimplemented bit

- n = Value at Power On

Reset

‘1’ = Bit is Set ‘0’ = Bit is Cleared X = Bit is unknown

There are two timers in FS98O22: Timer Module and Watch Dog Timer. Please see the following sections for

detail.

FORTUNE'

Properties

For Reference Only