Product Manual

12 517
1. With base on its side connect upright outer pole to base
using large (6mm) allen bolt. Tighten with large (6mm)
allen key p rovided. Tighten hardware as securely as
p o s s i ble. (Note: To prevent loosening, h a r d w a r e must be
tightened securely and periodically checked) (Figure 1).
2. Slide spring and stainless steel inner pole inside outer
pole with open end up (Figure 2).
3. Loosen (3mm) allen bolt on collar of cuff storage basket
with small (3mm) allen key provided. Place cuff storage
basket on top of stainless steel inner pole making sure
the pole goes completely inside collar and tighten allen
bolt with key (Figure 3).
4. Attach manometer to basket using (6mm) allen bolt and
washer as shown. Tighten securely with large (6mm) allen
key (Figure 4).
5. Connect tubing as noted in Wall configuration #4.
6. Adjust height of manometer by loosening adjusting knob
and raising or lowering inner pole until gauge is at desired
height. Tighten adjusting knob by hand (Figure 5).
Figure 4
Figure 1
Figure 2
Figure 3
Figure 5

How to Assemble Mobile Model
M e m o ry Function
M e a s u r ed result obtained in "AUTO" mode is automatically saved
in the memory and can be recalled until next measurement is taken.
The result is not saved when the measurement is perf o r m e d
in "MANUAL" mode.
To recall the result, turn on the device by pressing "I" side of
MAIN POWER SWITCH and set the device to "AUTO" with
MODE SELECTOR.
P r ess SET/MEMORY button and the last
result from "AUTO" measurement is displayed.
Tu r n off the device by press
ing "O" side of MAIN POWER SWITCH.
The device will be in the energy saver mode approximately after
3 minutes if it is not turned off. See page 10.