Product Manual

18 11
1. Securely attach wall bracket to flat surface using
enclosed mollys and screws at desired height.
(It is advised to use a level to ensure proper mounting).
( F i g u r e 1)
2. Attach manometer to wall bracket by lowering atop wall
bracket, sliding male tab into female seat of the bracket.
Secure the two together using the (6mm) allen bolt and
washer from below. Tighten secure l y with large (6mm)
allen wrench (Figure 2).
3. Securely attach cuff basket to flat surface to left of
manometer using enclosed mollys and screws at desired
height. (It is advised to use a level to ensure even
mounting) ( F i g u r es 3 - 4).
4 . Attach 8 foot length coiled tubing to air inlet on face of
e-sphyg 2
TM
(Figure 5).
I n s e r t “male” luer connector (891M) on free end of
coiled tubing to “female” luer connector (891F) on
bladder tubing (Figure 6). Fold cuff and store in basket.
Figure 2
Figure 3
Figure 6
Figure 4
Figure 1
Figure 5
How to Assemble Wall Model
E r ror Displays and Tro u b l e s h o o t i n g
ERROR SYMBOL/SYMPTOM C A U S E R E M E D Y
OVER-PRESSURIZATION: Make sure that
The cuff was inflated to the the patient
maximum pressure because stays still during
of movement of body, etc. measurement.
MEASUREMENT ERROR: Make sure the
Measurement could not be patient remains
made because of moving or still and quiet
talking during measurement. during measurement.
INFLATION ERROR: Reinsert AIR PLUG and make
AIR PLUG is not correctly s u r e that it is securely insert e d .
inserted.
Make sure that the patient
Noise was detected. stays still and quiet during
measurement.
DEFLATION ERROR: Make sure the patient
Movement or talking was remains still and
detected during measurement. quiet during measurement.
Extreme changes in pressure Do not let patient move during
occurred during measurement. measurement.
CHECKING MODE: Turn off the device once and
See page 21. then turn it on again to take
measurement.
NO POWER: Reinsert AC ADAPTER and
AC ADAPTER is not make sure that it is securely
correctly connected. inserted.
Battery is exhausted. Charge the battery or use
AC ADAPTER.
Nothing is being Turn off the device or press
displayed when 9002 was left turned on but START/STOP button or
MAIN POWER SWITCH has not been operated for SET/MEMORY button
is pressed down in the over an hour. to activate the device
ON position. from energy saver mode.