Product Manual

To set the day, use the «MEMORY» button. Press the3.
«TIME» button to confirm. To set the hour, use the
«MEMORY» button. Press the «TIME» button to
confirm. To set the minutes, use the «MEMORY»
button. Press the «TIME» button to confirm.
Once you have set the minutes and pressed the4.
«TIME» button, the date and time are set and the
time is displayed.
NOTE
If you want to change the date and time, press and hold the•
«TIME» button down for approx. 3 seconds until the user icon
starts to flash. Press the «TIME» button again; now you can enter the
new values as described above.
A single press of the «MEMORY» button or «TIME» button advances•
one operation.
Holding the button down speeds up the procedure.•
5.3. Select the User
This blood pressure monitor is designed to store 99 measurements for
each of two users. Before taking a measurement, be certain that the
correct user has been selected.
With the unit off, press and hold the «TIME» buttona)
to cycle between users ("1" and "2").
Press the «MEMORY» button to toggle betweenb)
users.
Press the «ON/OFF» button to make your selection.c)
5.4. Selecting the Measurement Mode (6016N only)
This instrument enables you to select either standard (single measurement)
or measurement averaging mode (automatic triple measurement).
To select Standard mode, push the switch on the sidea)
of the instrument to Position "1."
13
16
6.3. Fitting the Cuff
Remove all objects and jewelry (e.g. wristwatch) from the wrist ina)
use. Put the cuff over the wrist with the monitor face on the inside
of the wrist. The buttons should be on the bottom.
The distance between the cuff and the handb)
should be approx. 10 mm (1/2").
Secure the cuff with the hook and loopc)
fastener, so that it lies comfortably and not too
tight. No space should remain between the
cuff and the wrist.
Lay your arm on a table, with the palm upwards.d)
Support the arm a little with a cushion, so that
the cuff rests at about the same height as the
heart. Remain still for 2 minutes, before
beginning the measurement. You can also use
the storage case as a support.
6.4. Measurement Procedure
After the cuff has been appropriately positioned, the measurement
can begin:
Press the «ON/OFF» button. The built-in pump begins to inflate the cuff.1.
In the display, the increasing cuff pressure is continually displayed.
After a suitable inflation pressure has been reached, the pump2.
stops and the pressure gradually falls, with cuff pressures being
displayed. If that inflation pressure is not sufficient, the monitor
automatically re-inflates.
When the measurement has been completed, the systolic, and3.
diastolic blood pressures and pulse rate now appear in the display.
The measurement readings remain on the display until you switch4.
off the instrument. If no button is pressed for a period of 2 minutes
the instrument switches itself off in order to preserve the batteries.
1 3
93-6016N-00 rev 1 IFU_93-6016N-00 rev 1 9/30/14 1:54 PM Page 13