Specifications

8
3916067 01.13
4. Electrical Installation
4.1 General
Danger:Turnoffelectricalpowerbeforeservicing.Contactwithliveelectriccomponentscan
cause shock or death.
 ADC100isdesignedfor1x120VACpowersupplyonly.
The designations for each terminal on the control board are shown below. Note that some installations may not
require the use of all terminals. Also shown in this section is a general connection diagram for an ADC100
control system.
Terminal Use Terminal Use
1 Power Supply - L1 14-15 Damper Relay
2 Power Supply - N 16-17 Damper Prove
3 Power Supply - Ground 18-19 VFD Relay
4 Chimney Fan- L1 20 0-10 VDC Output
5 Chimney/Exhaust Fan - N (regulating) 21 0 VDC Output (Gnd)
6 Chimney/Exhaust Fan- Ground 22-23 Auxiliary Appliance Output 1
7 + 24 VDC Out (Max Amperage 250 VAC 8 A)
8 Ground (-24 VDC) Out 24-25 Auxiliary Appliance Input 2
9-10 Auxiliary Appliance Input 1 (10-240 VAC or 5-30 VDC)
(10-240 VAC or 5-30 VDC) 26 XTP- +24 VDC Out - Not Applicable
11 PDS- Normally Open 27 XTP In (0-10 VDC) - Not Applicable
12 PDS- Normally Closed 28 XTP In (0 VDC) - Not Applicable
13 PDS- Common 29-30 Auxiliary Appliance Output 2
(Max Amperage 250 VAC 8 A)
Fig.6
+24V
0-10
GND
XTP
26 27 28