Specifications

3916067 01.13

ADC 100

XTP

26 27 28

4.3WiringofaGasFireplace

 TointerlocktheADC100withagasreplaceasshowninFig.8,connecttheAuxiliaryInterminals9and10onthe 

control board to a wall switch. Either by using line voltage or use board voltage from terminals 7 and 8 as depicted

 ingure8.ConnectthegasvalveorignitiontoAuxiliaryOutatterminals22and23.TheAuxiliaryOutisanormally 

 opendrycontactthatcloseswhenthePDSclosesandreleasesthereplaceforoperation.TheAuxiliaryInterminals

are rated for maximum 250/125 VAC/VDC. Place a jumper between terminals 16 and 17 if the damper is not used.

Note: See Fig. 10 in Section 4.5 for connection of 3-phase fan with VFD.

Fig.8