User's Manual
Table Of Contents
- SECTION 1 General Information
- SECTION 2 InterReach Unison System Description
- SECTION 3 Unison Main Hub
- SECTION 4 Unison Expansion Hub
- SECTION 5 Unison Remote Access Unit
- SECTION 6 Designing a Unison Solution
- SECTION 7 Installing Unison
- 7.1 Installation Requirements
- 7.2 Safety Precautions
- 7.3 Preparing for System Installation
- 7.4 Unison Component Installation Procedures
- 7.5 Splicing Fiber Optic Cable
- 7.6 Interfacing a Main Hub to a Base Station or a Roof-top Antenna
- 7.7 Connecting Contact Alarms to a Unison System
- 7.8 Alarm Monitoring Connectivity Options
- SECTION 8 Replacing Unison Components
- SECTION 9 Maintenance, Troubleshooting, and Technical Assistance
- APPENDIX A Cables and Connectors
- APPENDIX B Compliance
- APPENDIX C Changes and New Capabilities
- APPENDIX D Glossary
InterReach Unison Installation, Operation, and Reference Manual C-1
D-620003-0-20 Rev K CONFIDENTIAL
APPENDIX C Changes and New Capabilities
To check the firmware version of any Unison component, launch AdminManager and
right-click on the component icon (main hub, expansion hub, or RAU) in the hierar-
chical tree. Select “Get Information” in the pull down menu.
LGC recommends that you use the latest firmware to optimize operations of your
Unison system. The latest firmware can be downloaded through the LGC Customer
Portal, accessible through our main website at www.lgcwireless.com.
C.1 New in Rev. K of Manual
• Support for 700 MHz Public Safety band
C.2 New in Rev. J of Manual
• Support for two new AWS bands
C.3 New in Rev. H. of Manual
• Supports scheduled system test.
• Supports 1 dB step attenuator and antenna disconnect in UMTS-2.
• Antenna disconnect alarm is user selectable between status and warning.
• Bookmarks for navigational ease
• Link to LGC Wireless customer portal for on-line configuration tools and product
compatibility information