User's Manual

Help Hot Line (U.S. only): 1-800-5 30-9960 7-29
D-620003-0-20 Rev K CONFIDENTIAL
Unison Component Installation Procedures
Connecting the Antenna to the Dual Band Diplexer
Connect a single passive antenna to the Dual Band Diplexer’s “Antenna” SMA con-
nector using coaxial cable with the least amount of loss possible.
CAUTION:Firmly hand-tighten the SMA female connector –
DO NOT over-tighten the connector.
7.4.4.2 Using Dual-Port Antenna
Connect both RAUs directly to a dual-port, dual-band antenna.
Figure 7-6 Dual-Port Antenna Configuration
7.4.5 Using a Cat-5 Extender
The Cat-5 Extender (PN #UNS-EX170-1)** increases the maximum length of the
Cat-5E/6 ScTP cable run that connects the Expansion Hub to the RAU from 100
meters to 170 meters. The minimum cable length between the Hub and Extender is 90
meters and the minimum length between the Extender and RAU is 20 meters. Beyond
the minimum lengths, an additional 60 meters of cable, maximum of 170 meters total,
can be inserted before or after the Extender.
Table 7-8 shows the minimum and maximum cable lengths that must be met:
Unison
RAU
Unison
RAU
Cat-5E/6 from Expansion Hub
Cat-5E/6 from Expansion Hub
Antenna
3 ft. coaxial cable
3 ft. coaxial cable
Expansion
Hub
Unison
Cat-5E/6 ScTP Cable
90 meters minimum
Unison
Cat-5
Extender
Cat-5E/6 ScTP Cable
20 meters minimum
170 meters maximum
RAU
295 feet minimum 65 feet minimum
557 feet maximum
** For Japan, refer to the separate addendum - Japan Specification Document.